FINAL DRIVE TRANSMISSION (CHAINCASE)
Checking And Adding Oil
The chaincase contains the final drive sprockets and
chains and uses the same type of oil as the
hydraulic/hydrostatic system See SPECIFICATIONS,
Page 9–1.
To check the chaincase oil level, use the following
procedure:
Drive the loader on a level surface. Stop the engine.
Remove the plug (Item 1) [A] from the front of the
chaincase housing.
If oil can be reached with the tip of the your finger through
the hole the oil level is correct.
If the level is low, add oil through the check plug hole until
the oil flows from the hole. Install and tighten the plug.
FAN GEARBOX
Checking And Maintaining
See the SERVICE SCHEDULE, Page 1–3 for the correct
service interval.
Raise the operator cab. (See Page 1–8.)
Remove the plug (Item 1) [B] to check the lubricant level.
If the level is low, add SAE 90W gear lube through the
check plug hole until the lubricant flows from the hole.
Install and tighten the plug.
A
P–01551
1
B
CD–15164
1
–1–26–
853, 853H Loader
Service Manual
853, 853H Service Manual #6720755 – Preventive Maintenance Section Part 1 of 2
Comments to this Manuals